求助] ProE.Wildfire.v3.0.M080怎麽安裝啊

1689438

謝謝  請告訴我!!!

junedyx

你不把破解发上来没办法告诉你哦，不同的破解的安装方法不同哦

独爱

传个附件给你看看.可能对你有用.

wival

我才刚用BT下载了个M070,这么快就有M080了
如何赶上~!~!

xie00001

原帖由 独爱 于 2007-6-12 09:49 发表
传个附件给你看看.可能对你有用.

请问：这个破解文件能用在　M080　　上吗

dreamsnow

我照下面的E文已装成功了（我是下载的VeryCAD上的M80 Shooters 版)

boot up your pc with windows
.start pro/e setup
.open ptc_licfile.dat with your fav txt-editor
.replace every occurance of <HOSTID> with the one shown in the bottom left corner of the Pro/e setup
(its your mac-id, format: xx-xx-xx-xx-xx)
.install pro/e - pro/m - pro/ds, i dont care which one or in which order
.on license-config screen select "nodelocked license" and point to edited ptc_licfile.dat
.blalala install
next for pro/engineer:
(if u didnt install the complete package, u get "missing file" errors, accept or bleed)
.run ptc.pro engineer.wildfire.3.0.generic-patch.exe, point to <installdir>\i486_nt\obj folder
.edit <pro/e installdir>\bin\proev.bat
  change "%start_cmd% "%CGTECH_JRE%\bin\javaw" -Xms16m -Xmx64m -Xss4m -classpath "%CGTECH_CLASSES%;%CGTECH_CLASSES%\CGTech.jar" Vericut %argstr%" in
        "%start_cmd% "%CGTECH_JRE%\bin\javaw" -Xms16m -Xmx64m -Xss4m -classpath "%CGTECH_CLASSES%;%CGTECH_CLASSES%\CGTech.jar" Vericut %argstr% PTC_KEY=0"
(add PTC_KEY=0)

pro/mechanica:
.run ptc.distributed.services.generic-patch.exe
.point to <pro/m installdir>\i486_nt\bin
       <pro/m installdir>\i486_nt\obj
       <pro/m installdir>\i486_nt\ptc
(in this order, after every "missing file" error)
pro/distributed services:
.run ptc.distributed.services.generic-patch.exe and point to <pro/ds installdir>\i486_nt\obj